Connecting the kitchen dishwasher
The kitchens are made different hydraulic works. Not all are complicated, because some performance takes only a few minutes.
This may be the installation of a kitchen tap, especially if the owners of the house they purchased a modern faucet that is simple to install.
Also repair this faucet should not cause major problems, although it may be that even the replacement of seals in a modern tap will only be possible during the visit plumber.
In recent years the standard of cooking was also the presence of a dishwasher, which helps housewife doing everyday activities related to washing dishes.
PVC pipe for plumbing applications and galvanized steel pipe for instance, are measured in IPS (iron pipe size). Copper tube, CPVC, PeX and other tubing is measured nominally, which is basically an average diameter. These sizing schemes allow for universal adaptation of transitional fittings.
Sometimes, however, when connecting the dishwasher must be present plumber.
You can need it
The difference between pipes and tubes is simply in the way it is sized.
For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing.
1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded male or female adapter to connect them.
When used in agricultural irrigation, the singular form "pipe" is often used as a plural.7
Pipe is available in rigid "joints", which come in various lengths depending on the material.
Tubing, in particular copper, comes in rigid hard tempered "joints" or soft tempered (annealed) rolls.
PeX and CPVC tubing also comes in rigid "joints" or flexible rolls.
The temper of the copper, that is whether it is a rigid "joint" or flexible roll, does not affect the sizing.7
The thicknesses of the water pipe and tube walls can vary.
Pipe wall thickness is denoted by various schedules or for large bore polyethylene pipe in the UK by the Standard Dimension Ratio (SDR), defined as the ratio of the pipe diameter to its wall thickness.
Pipe wall thickness increases with schedule, and is available in schedules 20, 40, 80, and higher in special cases.
The schedule is largely determined by the operating pressure of the system, with higher pressures commanding greater thickness.
Copper tubing is available in four wall thicknesses: type DWV (thinnest wall; only allowed as drain pipe per UPC), type 'M' (thin; typically only allowed as drain pipe by IPC code), type 'L' (thicker, standard duty for water lines and water service), and type 'K' (thickest, typically used underground between the main and the meter).
Because piping and tubing are commodities, having a greater wall thickness implies higher initial cost.
Thicker walled pipe generally implies greater durability and higher pressure tolerances.Źródło: https://en.wikipedia.org/wiki/Water_pipe#Difference_between_pipes_and_tubes
Water systems - materials
Water systems of ancient times relied on gravity for the supply of water, using pipes or channels usually made of clay, lead, bamboo, wood, or stone.
Hollowed wooden logs wrapped in steel banding were used for plumbing pipes, particularly water mains.
Logs were used for water distribution in England close to 500 years ago.
US cities began using hollowed logs in the late 1700s through the 1800s.8 Today, most plumbing supply pipe is made out of steel, copper, and plastic; most waste (also known as "soil")11 out of steel, copper, plastic, and cast iron.11
The straight sections of plumbing systems are called "pipes" or "tubes".
A pipe is typically formed via casting or welding, whereas a tube is made through extrusion.
Pipe normally has thicker walls and may be threaded or welded, while tubing is thinner-walled and requires special joining techniques such as brazing, compression fitting, crimping, or for plastics, solvent welding.
These joining techniques are discussed in more detail in the piping and plumbing fittings article.Źródło: https://en.wikipedia.org/wiki/Plumbing#Materials.